Scope Accessories
Highly recommended to prevent movement of any scope on spring-piston airguns or stronger recoiling firearms. Just slip on behind position of scope mount and secure with included Allen wrench.
Cat. Number 5092 -- Install behind mount: Beeman C1 and P2; Spitfire; all Webley; BSA; Falcon 2, FX-2, Kodiak, Feinwerkbau 124, 127, 300. Install ahead of mount: Beeman P1, Hurricane, 5140.
Same function as 5090 unit, but more sophisticated. Multiple part design clamps firmly onto sides of gun's dovetail and has a large stop pin as well. Beautifully made, beautifully blued--you'll be delighted if you appreciate extra quality and fine details. Fits only Beeman R series rifles, Beeman/HW, Weihrauch air rifles, and Marksman 60-61, 28, 40, 55, 59 and 70 Series, Diana.
Cat. Number 5093.
Rear Sight Replacement Plates
These plates neatly replace the rear sight when scope or receiver sights are installed. A better arrangement than using filler screws as the plates also cover an unsightly hole or groove that is revealed when rear sight is removed. Uses existing rear sight screw holes. Screws provided.
Cat. Number 5150--Fits Beeman R1, R9, RX. Blued gun steel.
Cat. Number 5151--Same as above, but fits Beeman R7/R8, HW30, HW50.
FWB Intermount
This factory unit raises the scope mount or aperture sight up to a "heads-up" position that is most suitable for running target and which is also preferred by many for other forms of shooting.
Fits FWB 300S Match, Mini-300, Running Boar, etc., rifles. Especially for use with Beeman 66R and 66RL scopes. Also provides extra room for easier loading.
Cat. Number 5435.
Note: 5142 does not require drilling and tapping, use existing rear mount screw holes.
